ADCP-96-088 • Issue 2 • 6/2013
Page 45
© 2013, Tyco Electronics Corporation. All Rights Reserved.
Figure 39. Splitter Compartment Adapter Replacement
6. Install the replacement adapter assembly in the splitter compartment and secure it by
turning the thumbscrew counter-clockwise until tight.
7. Clean the feeder cable connector(s) as specified in the Optical Fiber Systems Cleaning and
Mating Instructions (ADCP-90-159).
8. Connect the feeder cable connector to the rear side of the replacement adapter assembly.
9. Connect the dust cap or splitter to the front side of the replacement adapter assembly.
10. Close the cabinet swing frame.
10.4 Replacing a Damaged Fiber or Connector
A damaged fiber or connector can usually be replaced. The following describes the various
replacement options.
•
Damaged Splitter Output Fiber:
Replace the splitter output fiber from the connector all
the way back into the splitter. Splice a new pigtail (use only pigtails with bend-optimized
fiber) to the remaining section of the old fiber within the splitter chassis. This procedure
requires removing and disassembling the splitter to insert a splice chip and to perform the
splice. A kit is available from ADC. Refer to ADCP-96-034 for the procedure.
•
Damaged Distribution or Feeder Connector:
Replace the connector at the bulkhead
adapter if just the connector alone is damaged. Use a field-installable connector
replacement kit. Refer to
for the replacement procedures.
REAR VIEW OF
SPLITTER COMPARTMENT
ADAPTER
ASSEMBLY
THUMB
SCREW
21407-A
FEEDER CABLE
CONNECTOR
DUST CAP
OR SPLITTER