ADCP-96-088 • Issue 2 • 6/2013
Page 24
© 2013, Tyco Electronics Corporation. All Rights Reserved.
6
PLUG AND PLAY SPLITTER MODULE INSTALLATION
The 864 termination FDH 3000 cabinet can accommodate up to forty-eight splitter modules.
Depending on the splitter type, plug and play splitter modules are equipped with either one or
two input connectors. Inserting the splitter into the splitter compartment connects the splitter
input connector(s) to the feeder cable connector(s).
Each plug and play splitter module is equipped with up to 32 connectorized output fibers. The
splitter output fibers may be stored for later use or routed to the distribution panels for
connection to the distribution ports. Additional instructions for installing plug and play splitter
modules are provided in the FDH 3000 Plug and Play Splitter Installation Guide (ADCP-96-
087). Use only splitters equipped with bend-optimized fibers.
Use the following procedure to install additional splitters in the cabinet:
1. Locate the splitter module compartments that are mounted on top of each swing frame as
shown in
.
2. Identify the next available splitter mounting position.
Figure 17. Splitter Compartment Layout - Top View
Note:
Install splitters in the order shown in
. When the splitter compartment on
the left swing frame is filled, use the splitter compartment on the right swing frame.
LEFT
SWING FRAME
SPLITTER
MODULES
RIGHT
SWING FRAME
SPLITTER
MODULES
21611-B
SLOTS
1 - 12
SLOTS
1
3
- 24
SLOTS
3
7 - 4
8
SLOTS
25 -
3
6
1
2
3
4
5
6
7
8
9
10
11
12
1
3
14
15
16
17
1
8
19
20
21
22
2
3
24
26
27
2
8
29
3
0
3
1
3
2
33
3
4
3
5
3
6
25
3
7
38
3
9
40
41
42
4
3
44
45
46
47
4
8
