114-94438 REV C1
15
of 36
6.5.
Assembly Steps
Step 1
The COVER CABLE SEAL AC [Pos. 9], STRAIN RELIEF AC [Pos. 8] and FAMILY SEAL AC [Pos. 7]
must be pushed over the signal wires, the ground wire and the AC-Multicore wire. Pay attention to place
all wires at correct positions. (Figure 14).
Step 2
Preparation of AC multicore cable.
THE SINGLE BRAIDS MAY NOT BE CUT OR DAMAGED DURING DISMANTLE PROCESS.
Remove outer isolation, shield and filler of AC-multicore-cable acc. figure 15.
The given length of the single wires shown in table 3, ensures that the outer isolation of the multicore
cable seals off to the FAMILY SEAL AC [Pos. 7.
A marking on outer isolation in a distance “C” (or in a
offset to “C”) to the cut off position is recommended to
ensure the proper position of the outer isolation
in the FAMILY SEAL AC [POS.7]
.
Wire Size
Removal of isolation
"A"
Length of single
wires “B”
Position outer end of
COVER [POS.9]
“C”
6 mm²
13 +/-1 mm
68 +/-2 mm
96 +/-4 mm
Table 3
Figure 14
Figure 15
Summary of Contents for CCS1
Page 26: ...114 94438 REV C1 26 of 36...
