Tool Holder
Guard
Guard
Applicator Base
Tool Holder
Applicator Base
Guards on the applicator may differ from the guards shown in the illustrations.
End-Feed Through-Splice Applicator for Through-
Splice Applications in AMP 5K/40 CE Terminators
Side-Feed Through-Splice Applicator for Through-
Splice Applications in AMP 5K/40 CE Terminators
© 2012 Tyco Electronics Corporation, a TE Connectivity Ltd. Company
All Rights Reserved
*Trademark
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 11
Instruction Sheet
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com
LOC B
408-32027
End-Feed and Side-Feed
Applicators for AMP 5K/40* CE
Through-Splice Terminators
08 FEB 12 Rev A
Figure 1
1. INTRODUCTION
Side-Feed and End-Feed Through-Splice Applicators
(Figure 1) for AMP 5K/40 CE Through-Splice
Terminators apply strip terminals to pre-stripped wires.
Each applicator accepts the strip form of certain
terminals, which are identified on the applicator parts
list and exploded view drawing (Applicator Log) for
each applicator. The terminal listed on the applicator
data plate is the one that was specified when the
applicator was ordered. Some terminals have two
carrier strips, others just one.
Additionally, these instructions cover the differences
between the AMP 5K/40 CE through-splice terminator
for through-splice terminals (Figure 1) and the
AMP 5K/40 CE Terminator 2161500-[ ] for end of wire
applications.
Refer to customer manual 409-10204 for general
machine information about the AMP 5K/40 CE
Terminating Machines.
This instruction sheet, the parts list and the exploded
view drawing packaged with the applicator and
409-10204 provide all the information required to
operate and maintain the applicator and machine
.
When reading this document, pay particular attention
to DANGER, CAUTION, and NOTE statements.
DANGER
STOP
Denotes an imminent hazard which may result in
moderate or severe injury.
CAUTION
!
Denotes a condition which may result in product or
equipment damage.
NOTE
i
Highlights special or important information.
O
R
IG
INAL
INST
RUCTIONS
