408-160034
Rev
A
7
of 8
c. Terminal Feed Position
(1) A strip of terminals must be loaded into the strip guide and fed forward until the end terminal is
exposed out the frontside of the strip guide and over the anvil.
(2) Adjust the forward feed mechanism stop position. To adjust, pull the manual feed mechanism
handle forward until it is biased against the forward feed mechanism stop position screw.Turn
the screw clockwise or counter-clockwise until terminal is visually centered over the anvil.
When the desired position is achieved, lock down the forward feed mechanism stop position
screw by tightened the locking nut while carefully making sure the adjustment position is
maintained.
(3) Adjust the rear limit stop collar. To adjust, loosen the set screws securing the rear limit stop
collar. Manually adjust the rear limit stop collar position so that the feed mechanism has
enough back stroke to pick up the next terminal when it retracts. Include some over-travel to
allow the spring-loaded feed finger to snap behind the next terminal.
Figure 11
d. Tooling Pack Mounting Orientation
NOTE
Mounting orientation position #1 is the preferred mounting for most applications.
(1) Four tooling pack mounting orientations are possible. The orientation can be adjusted by
moving the mounting screw and square nuts to a different mounting hole location (Figure 12).
Figure 12
