V6 Optional Pan/Tilt Unit
Control unit that allows remote or manual adjustments to the VC-04’s
horizontal (pan) and vertical (tilt) position. The VC-04 has a mounting plate that will screw onto
the Pan/Tilt unit.
Installation Instructions
The video camera system installation is simple, requiring only the following steps:
1
Mount the components in their respective locations (control room, chamber, other remote
locations).
2
Install cable runs between control room and remote locations.
3
Connect the SI-300CC to the video monitor(s) using the BNC cable(s).
4
Connect the SI-300CC to the camera(s) using the fiber optic cable(s).
5
Connect the SI-300CC to the control computer using the IEEE-488 serial cable.
6
Power on the monitor, camera(s), and camera controller.
Connecting the Video System Components
Make sure the cables are positioned away from moving parts and do not interfere with the
movement of the rack in any way.
SI-300CC to Video Monitor
Connect the video monitor to the SI-300CC rear panel using
the BNC cables supplied.
Connect the Video OUT on the SI 300CC to the Video IN on the monitor.
Connect the optional Audio OUT on the SI-300CC to the Audio IN on the monitor.
S1
S2
*S1 and S2 refer to item numbers on the product diagrams (pages 5 and 6).
SI-300CC to VC-04
Connect the remote cameras to the SI-300CC rear panel using the
fiber-optic cables supplied. Each camera communicates with the SI-300CC using an RS-232
serial communication link that requires a fiber-optic cable with two fibers, one RX (reception)
and one TX (transmission). The RX and TX taken together are considered one channel.
Connect the RX port on the SI-300CC to the TX port on the remote camera, and
the TX to the RX. The SI300CC has a dedicated channel for each remote device,
which needs to be connected to the assigned fiber-optic port. The ports are re-
configurable via the front panel and computer interface.
S3 V3
SI-300CC to VC-04
Connect the VC-04’s video signal cable and optional audio signal cable
to the SI-300CC’s rear panel video and audio receiver ports.
Connect the Video IN on the SI-300 to the Video port on the VC-04. This
transmitter will emit a red light when the video is functioning properly.
Connect the optional Audio IN on the SI-300 to the Audio port on the VC-04.
This transmitter will emit a red light when the video is functioning properly.
V3
S1
V3
S2
TDK RF Solutions
Video Camera System
User Manual
7
Summary of Contents for VCS-04
Page 2: ......
Page 15: ...TDK RF Solutions Video Camera System User Manual 9 ...