WCL488 Series Water Cooled Electronic Loads
Operation & Programming Manual
TDI-Dynaload Division
Page iv
402828, Rev. B1
WCS UV (Undervoltage Lockout) Switch ..............................................................42
WCS Relay Connector.............................................................................................43
WCS Chassis Ground Connection...........................................................................44
Slave Bit Identifier Switches ...................................................................................44
Chapter 3 — IEEE-488 Commands and Programming................................ 45
Introduction..........................................................................................................45
IEEE-488 Bus Subsets .........................................................................................45
Data Separators....................................................................................................46
Program Line Terminators.................................................................................46
Numerical Data Formats.....................................................................................46
Numerical Data Units ..........................................................................................46
Power-on Defaults................................................................................................48
Commands............................................................................................................49
Queries ..................................................................................................................49
Command and Queries Listed Alphabetically ..................................................50
Commands and Queries Listed by Category ....................................................53
Configuration......................................................................................................53
Identification.......................................................................................................53
Limit Control ......................................................................................................53
Load Control.......................................................................................................53
Operation Modes ................................................................................................54
Pulsing ................................................................................................................54
Pulsing Level Parameters....................................................................................55
Readbacks...........................................................................................................55
Slew Rate Commands.........................................................................................55
Status Related Commands ..................................................................................56
Miscellaneous .....................................................................................................56
Detail Language Elements...................................................................................57
AV1
Amps/Volt Pulsing Base Level
...................................................................57
AV2
Amps/Volt Pulsing Peak Level
...................................................................58
