15
05/2006
Programming an already programmed bell button
Basic principle
A bell button can be linked to two serial numbers (of two in-house stations). It is then pos-
sible to have two different in-house stations ring at the same time.
Connect the in-house stations to the TCS:BUS.
Use one of these two methods.
Method 1
:
In-house station not accessible
1
LED illuminates
Press briefly
LED flashes
programming
mode
of system
switched on
2
Floor-switch button within 3 sec:
press 1 sec, until bell rings - release - press 1 sec until bell rings - release.
3
Press
... and
... and ring tone sounds release
until
Noprog tone
at front-door and
Prog2 tone sounds
1)
... sounds
in-house station.
bell button
programmed
4
Press briefly
LED illuminates
programming
mode
of system
switched off
Programming the other already programmed bell buttons
•
Step
1
•
repeat steps
2
and
3
each time
•
complete the programming of all buttons with step
4
TCS TürControlSysteme AG
•
Geschwister-Scholl-Str. 7
•
39307 Genthin
Subject to change without notice.
Phone.: +49 39 33 / 87 99 10
•
Fax: +49 39 33 / 87 99 11
•
www.tcs-germany.com
PI_GB_VPES_VPDS_Art0016079_2v0.doc
mi
