TCS PUK Series, Product Information

Page: 9 / 16

9 11/2012
TCS TürControlSysteme AG, TCS Hotline Germany: +49 (0) 41 94/ 9 88 11 88 Subject to technical changes.
FAX: +49 (0) 41 94/ 9 88 129

Mail: info@tcsag.de PI_PUK-uk 1 A
Bell button programming
Basic principle

All devices at the TCS:BUS have got an unique serial number.

When programming a bell button, the serial number is allocated to an indoor station and
stored in the EEPROM of the front-door station. Per bell button, 1 or 2 indoor stations
(serial numbers) can be allocated and called.

When a bell button is not allocated to a serial number (condition ex works/allocation de-
leted), this button can be used to switch lights.
Programming a bell button
Make sure that the indoor station is connected to the TCS:BUS and the mains voltage is
switched ON (the LED at the power supply / control unit is ON).
!
Before an already programmed bell button can be programmed anew, the previ-
ous programming must be deleted.
Legend
press button shortly busy ton
press button until
negative acknowledgement tone
(bell buton already programmed)
release button SNapp tone
LED blinks
negative acknowledgement
signal (NoProg tone)
LED blinks fast delete-melody
LED is ON
Prog2 tone (start programming of
the 2nd serial number)
ring tone repeat
progsperr tone further
period of time (e.g. 6 sec)
◄6s►