34
The image "rolls".
The video signal cannot
be synchronized.
Please check, if all wires of the
video BUS are connected.
Eventually you have to readjust
the level.
Multiple contours
occur
Image reflections occur,
so called "ghost images",
due to open lines.
The video strand is not connect-
ed.
Please place the matching resis-
tor in the last device of the
strand.
Contours of a second
image are visible.
Two video sources inter-
fere.
Please remove the second video
source from the strand.
Connect the second video
source, if necessary, via a video
switch to the existing TCS:BUS.
No image. When
pressing the image
button there is no
respond.
No signal present.
Connect the monitor before the
video switch and check if there is
a signal.
Measure the voltage between P
and b. The voltage is around 24
V. If this is not the case, check
the BUS voltage supply.
Not both wires of the
video BUS are connect-
ed.
Please check the correct connec-
tion of the connection terminal.
The video image
turns white after a
while. Switching the
supply voltage off and
on again, the signal
will be normal again.
The video image
turns white after a
while again.
Thermal defect of the
outdoor camera.
One of the wires of the video
BUS short-circuits the P- or the
a-wire. This causes an impermis-
sible increased current.
Please check the wiring for short-
circuits.
The camera is defect.
