13
Connect the lines
Minimize the length of the lines
above the lower cover to place the
lines without any problems and do
not clamp the lines when snapping-
on the upper cover.
Connect the lines to the pluggable
terminal according to the labeling
within the lower cover. (Terminal
can be removed from the guide.)
Put the lines in the designated ar-
ea.
Ensure that no uninsulated or not
connected wire (e.g. cable shield)
is placed in the device as this might
cause short-circuits.
a
b
E P
M
C V1
V
2
Setup the indoor station
as end device
The indoor station is placed at the
end of a strand or is the only device
at the strand.
The jumper
J1
bridges the two
lower contacts. Thus, the matching
resistor is placed.
scope of
delivery state:
not plugged
