10
10/2012
TCS TürControlSysteme AG, TCS Hotline Germany: [email protected]
Subject to technical changes.
FAX: +49 (0) 41 94/ 9 88 129
PI_AVC11010-uk 1A
Cleaning
!
Avoid water from entering the device!
Do not use any abrasive detergents!
Clean the device with a dry or slightly wet cloth.
Remove stronger stains with a mild household cleaner.
Repair
Replacing an indoor station
– programming bell buttons
Basics
All devices at the TCS:BUS have a unique serial number.
Programming a bell button means that the serial number of an indoor station is allocat-
ed to the bell button of a front-door station and is further stored within the EEPROM of
the front-door station.
Ensure that the new indoor station is connected to the TCS:BUS and the mains voltage
is switched ON (the operation LED at the power supply and control unit is ON). Further
ensure that the access to the flat is granted during the programming.
This instruction describes the allocation of a serial number to a bell button without set-
ting a programming lock. To deactivate a programming lock, a Service Device TCSK-
01or the configuration software confi
go™ is needed.
1
Initiate
Power supply and control unit
shortly press
LED blinks
Programming mode of the system is switched ON
2
Delete a button
a)
Press until the delete-tone melody sounds
1)
release
