05/2013
17
TCS TürControlSysteme AG, TCS Hotline Germany: [email protected]
Subject to technical changes.
Fax: +49 (0) 41 94 / 9 88 129
PI_AMI_FG-DISPLAY-uk 2A
Repair
Display module AMI1010x: Replace the EEPROM storage
!
Modifications of dataset and parameter are not stored automatically.
After all modifications, carry out the following steps
Various > save storage
, to trans-
fer the modifications on the EEPROM (see enclosed programming manual
Func-
tional group with display module AMI1010x
).
All programmed data such as serial numbers and parameter are stored in the EEPROM. If
the front-door station needs to be replaced, the EEPROM storage can be removed from
the programmed front-door station and installed into the new,
comparable
front-door sta-
tion.
1.
Eventually save the data of the display (
Various > Save storage
).
2.
Open the housing.
3.
Disconnect the display from the power supply: pull off the connection socket.
4.
The EEPROM storage is located in the elctronic part (corresponding to the display
module). Pull off the EEPROM storage.
5.
Plug the EEPROM storage into the new, unprogrammed display module on the pins.
!
Observe the orientation of the EEPROM storage: the component site must be facing
you.
6.
Connect the front-door station to mains voltage again.
7.
Conduct
Load storage
. Observe the software version (
Various > Load storage
, page 20)
to transfer the data into the electronic module.
Observe when transfer data from a previous version
After the upload process is finished (step 7), remove the EEPROM storage of the dis-
play front-door station DIT (software version 2.7.x / 3.x.x) out of the display module
again.
Otherwise the real time clock doesn’t work any longer.
