TC-Helicon VoiceWorksPlus, User Manual

Page: 12 / 49

8
BACK PANEL DESCRIPTIONS
1. Mic Input
When the MIC IN switch on the front panel is lit, this
becomes the main analog input. It accepts a balanced
mic level XLR cable carrying a monophonic vocal
source.
2. Line Input
When the MIC IN switch is not lit, this 1/4” jack
becomes the main analog input.You can connect either
a balanced (3 conductor TRS) or unbalanced (2
conductor TS) -equipped cable here. The input
sensitivity for the line input is located in the Setup
menu.
This jack can alternately be used as an auxilliary input
to the
μ Mod, Delay and Reverb effects blocks in
VoiceWorksPlus. This allows VoiceWorksPlus to do
double duty as both a harmony processor for your
voice and also a multieffect for other instruments or
vocals in your mix.To use this input, the MIC IN must
be set as the main vocal input.The effects level settings
are located in the Edit menu.
3. Balanced Outputs
These are the balanced analog, line level stereo output
of VoiceDoubler.You can connect either a balanced (3
conductor TRS) or unbalanced (2 conductor TS) -
equipped cable here. You can sum the left and right
outputs to mono by changing the Output parameter in
the Setup menu.
4. Digital I/O
Sends and receives digital audio. Using digital I/O
instead of the analog I/O bypasses VoiceWorksPlus’
converter circuitry for enhanced audio clarity when
used with compatible systems.The digital output (DO)
is configured to always produce the same audio as the
main outputs.The Input parameter in the Setup menu
must be set to Digital for the digital input (DI) to
receive audio. Also, the ClockSrc must be set to
Ext(ernal) for proper audio synchronization when
using the digital input.
5. MIDI
This is the standard MIDI In, Out and Thru interface
used to allow editing, preset selection, preset dump
and restore functions.
6. Pedal
This input accepts a single function footswitch or a
triple function footswitch. Any normally-open passive
footswitch will work for the single function footswitch.
A triple function footswitch is available from TC-
Helicon called
Switch 3 . The switch type or volume
pedal is detected automatically on power up. If you plug
your footswitch in after power up, you may get
unexpected operation.
Footswitch (Pedal) features:
1 button footswitch: Bypass only
3 button footswitch: individually selectable in
Setup menu
1 2 3 4 6 5
8