TC-Helicon VoiceWorksPlus, User Manual

Page: 11 / 49

777
FRONT PANEL DESCRIPTIONS
BYPASS button
Pressing BYPASS mutes all processing blocks of
VoiceWorksPlus. Any audio signal that is received at
the line or mic input is passed directly to the left and
right audio outputs.
STORE button
Pressing STORE initiates the storing sequence and
presents the preset name and target user preset
number in the main display. In Store mode, you can edit
the name of the new preset by turning the EDIT 1
knob to highlight the letter positions and then using
EDIT 2 to change the letter.You can press either EDIT
or SETUP to cancel a Store operation or press STORE
or the Data Wheel to complete.
8.The Data Wheel
The Data Wheel has two actions: you can turn it and
you can press it. When the display shows a preset
name, turning the Data Wheel allows you to browse
through the available presets. You can then press the
Data Wheel to load the preset of your choice.
If you’ve pressed the EDIT or SETUP buttons, this
wheel cycles up and down through the menus available
in these modes. Pressing it has distinct functions in
some menus.
When the STORE button is lit, turning the Data Wheel
allows you to choose a user bank preset number in
which to store your edited preset and pressing it
completes the Store operation
9. Mic Input control group
MIC GAIN knob
The MIC GAIN knob allows you to tailor
VoiceWorksPlus’s input gain to match your
combination of microphone sensitivity and singing
level.
MIC IN button
The Mic In switch controls which of VoiceWorksPlus's
inputs: Mic In or Line In, will drive the unit.This switch
must be lit before any adjustment of the MIC GAIN
and phantom power will have any effect.
48V button
You must press and hold this button for approximately
1 second to send DC voltage to condenser
microphones requiring phantom power. When using
non-phantom powered mics, leaving this off is best.
-20 dB switch
This switch reduces the sensitivity of the mic input
when you use mics that have a high output level. You
would press this switch when you notice that even
though the MIC GAIN knob is set to minimum (fully
left), the Input Clip LED shows clipping during singing.
In this case, press the -20 dB switch and you will have
more range adjustment with the Mic Gain control.