31
rOuTInG - paGe
operation
Routing
Introduction
The Routing page is the patch bay of the DB8/DB4
Mainframe. All routings of physical Inputs/Outputs as well
as internal routing between Engines is setup here.
The understanding of this page is therefore essential to
operating the DB8/DB4.
To access the Routing Page:
• Press
Frame
(upper tab)
• Press
Routing
(side tab)
• Press
Route
to enable routing facilities
This is the page where you:
• Have the overall view of all I/O’s
• Route physical Inputs to Engine Inputs
• Route Engine Outputs to physical Outputs
• Access Input and Output meters
Routing Inputs
• Press the
Route
key to select route operation.
• Press Engine 1-4 to select the Engine you
wish to route
• Select a physical Input or another Engine’s Output using
Fader 1
• Select Engine Input using
Fader 2
Routing Outputs
• Press the
Route
key to select Route operation
• Press Engine 1-4 to select the Engine you wish to route
• Select an Engine Output using
Fader 5
• Select Physical Output using
Fader 6
The I/O possibilities are as follows
• It is possible to route an Input to several
Engine Inputs (up to 32), however, it is not possible to
connect more than one physical Input to the same
Engine Input.
• It is possible to connect all Engine Outputs (up to 32) to
one single physical Output.
• It is possible to connect an Engine Output to the Inputs
of the three other Engines.
Engine Processing Delay
Processing delay between the routed Engines
behaves as if they were external devices.
Labels
The Input/Output fields can show either meters or the
Labels/names on the Input/Output channels. To switch
between the two modes, press “Labels”.
Renaming Physical Inputs and Outputs
Input and Output channels can be labeled individually. This
is a global renaming process and is accessed by pressing
System
(side tab) followed by
I/O
and
Labels
.
Meters
Engine I/O Meters
Engine I/O meters are shown at the left and right of the
large E 1-4 buttons in the middle of the display. The
number of meters shown will always reflect the number of
I/O channels in the loaded algorithm.
Frame - E1 to E4/E2 (DB8/DB4)
This page holds the User group parameters for all four
Engines. Selecting User group parameters is done from the
Engine pages. Values can be altered from both the Engine
Edit pages and the page displayed above. Press the
parameter you wish to assign to the Fader located below.
