6
5.
Installation of the unit with the multicontroller or the 8 channel DMX
controller
Only original parts from the manufacturer may be used for the installation.
The Jet-Master works with highly compressed CO
2
gas, which becomes
extremely cold when it evaporates (-70°C). All parts of the unit are
specifically designed and selected by the manufacturer and must neither be
changed nor replaced with other parts.
Ensure good stability and fastening when setting up the device, as the
emission of the CO
2
gas causes recoil. Always mount the nozzle in a direction
where the emitted gas stream cannot represent a hazard for persons. The
pressure cylinders must be operated upright (vertically) and secured against
tilting.
After the safe installation of the CO
2
pressure cylinder mount the high-
pressure hose. Put the included hard gasket/copper gasket on the gasket face
within the screw connection of the CO
2
cylinder and tightly screw the hose to
that fitting (right-hand thread).
Connect the Jet-Master with a 5-pin XLR-cable to an usual DMX-512 controller
and with the power cable to a power source of 230 V AC.
Now the DMX-channel can be set. The Jet-Master is equipped with a safety
function. Triggering the Jet-Master is only possible if the device is unlocked
via DMX. The selected DMX channel, indicated on the 7-segment displays, is
the channel for unlocking. The activation of the Jet-Master is triggered with
the proximate DMX channel. Thus the Jet-Master can only be activated when
both channels are triggered at the same time.
Example: Channel 001 is selected in the segment display. The clearance
(unlocking) effects when the DMX console sends a signal on DMX channel
001. If the DMX console now sends a signal on channel 002 the Jet-Master
will be activated.
Now open the hand valve of the pressure cylinder. In case of leakage, either
tighten the screw connection or replace the gasket. The unit is now ready.
ENSURE THAT NOBODY IS WITHIN THE SAFETY AREA OF THE STEAMER'S
NOZZLE WHEN TRIGGERING THE FOG COLUMN!!
ATTENTION: DO NOT TRIGGER THE JET-MASTER LONGER THAN 5 MINUTES!
6.
Shut-down
Shut the hand valve of the CO
2
pressure cylinder. The unit is then
depressurized by activating the unit. Disconnect the unit from power supply
and then unscrew the high-pressure hose. Disassembly can now begin in
reverse order.
Keep in mind that the nozzle and all metallic parts of the unit may be
extremely cold!
