Energy Hub User Manual
8
➢
Do not install on flammable building materials.
Step 3: Wiring the system
Please make sure that the positive and negative polarity connections are correct and reliable.
1. Please connect one end of the prepared wire to the generator and the other end to the
ALTERNATOR
interface of the Energy Hub with an Anderson connector.
2. Please connect one end of the prepared wire to the inverter and the other end to the
INVERTER
interface of the Energy Hub with an Anderson connector.
3. Please connect one end of the prepared wire to the C12 load module and the other end to the
DC LOAD
interface of Energy Hub with an Anderson connector.
And please connect your DC
load to the C12 load module. If you have purchased our Solar Mate, please connect the BAT+
and BAT- of the
Solar Mate
to the DC LOAD interface of the Energy Hub.
4. Please connect one end of the prepared network cable to the RS485 interface of the inverter
and the other end to the
Inverter
interface of the Energy Hub. If you have purchased our Solar
Mate, please use the RJ45 adapter to connect the RS485 port of the Solar Mate and the RS485
port of the inverter to the Inverter interface of the Energy Hub at the same time. Attached is the
IH RS485 port wiring diagram:
Summary of Contents for Energy Hub EH128L
Page 1: ...Preface...
Page 24: ...Energy Hub User Manual 21...
