Taylor Freezemaster 336, Original Operating Instructions

Page: 24 / 46

6-2
OPERATING PROCEDURES
Model 336, 338, 339
Operating Procedures
6
3. Take one of the scraper blades and slip it under the
hook at the front of the beater. Wrap the blade
around the beater, following the helix and pushing the
blade down onto the helix as you wrap. At the back
end of the beater, slip the blade under the hook.
Repeat this step for the second scraper blade.
Figure 6-3
4. Holding the beater securely, slide the beater one third
of the way into the freezing cylinder. Looking into the
freezing cylinder, align the hole at the rear of the
beater with the flats on the end of the drive shaft.
Figure 6-4
5. Slide the beater the remainder of the way into the
freezing cylinder and over the end of the drive shaft.
The beater should fit snugly, but not so tightly that the
beater cannot be turned slightly to engage the drive
shaft. If the beater slides in with little or no resistance,
there will not be enough force against the beater to
hold the blades in place. If this is the case, contact
your authorized Taylor service agent.
6. Repeat step 1 through step 5 for the other side of the
freezer.
7. Assemble the freezer door. Place the large rubber
gaskets into the grooves on the back side of the
freezer door.
Slide the white plastic front bearings over the baffle
rods onto the bearing hubs, making sure that the
flanged end of the bearing is resting against the
freezer door.
DO NOT LUBRICATE THE GASKETS OR
THE FRONT BEARINGS. Damage to components may
occur.
Figure 6-5
8. Slide the two O-rings into the grooves on the prime
plugs. Apply an even coat of Taylor Lube to the O-
rings and shafts.
Figure 6-6
!