OPERATING PROCEDURES
6-3
Model 490
Operating Procedures
6
9. Lubricate the inside of the freezer door spout, top
and bottom, and insert the draw valve into the freezer
door from the top. It will be necessary to rotate the
draw valve to the right when installing the door on the
freezer.
Figure 6-8
10. Place the O-ring onto the prime plug and lubricate.
Figure 6-9
11. Screw the prime plug into position on the front of the
door.
Figure 6-10
12. Place the freezer door gasket into the groove on the
back of the freezer door. Slide the front bearing over
the baffle rod so the flanged edge is against the door.
Important! Do not lubricate the gasket or bearing.
Figure 6-11
13. Insert the baffle rod through the beater in the freezing
cylinder. With the door seated on the freezer studs,
install the handscrews. Tighten equally in a
crisscross pattern to ensure the door is secured.
Figure 6-12
14. Rotate the draw valve bracket to the left and center it
into position by raising the draw arm and placing it
into the slotted groove of the draw valve bracket.
11398
Apply the appropriate
Taylor approved food safe lubricant.
Apply the appropriate
Taylor approved food safe lubricant.
11400
Apply the appropriate
Taylor approved food safe lubricant.
11399
11401
101107
Summary of Contents for 490
Page 16: ...4 4 OPERATOR PARTS IDENTIFICATION Model 490 Operator Parts Identification 4 Notes...
Page 18: ...5 2 USER INTERFACE Model 490 User Interface 5 Notes...
Page 32: ...9 2 PARTS REPLACEMENT SCHEDULE Model 490 Parts Replacement Schedule 9 Notes...
Page 38: ...11 4 LIMITED WARRANTY ON PARTS Model 490 Limited Warranty on Parts 11 Notes...
