![background image](http://html1.mh-extra.com/html/taylor/441/441_operators-manual_3761960024.webp)
20
Operating Procedures
Models 441 & 444
Step 3
From the freezer door(s) remove:
S
the gasket(s)
S
the front bearing(s)
S
the draw valve(s)
Remove all o- rings.
Note:
To remove o- rings, use a single service towel
to grasp the o- ring. Apply pressure in an upward
direction until the o- ring pops out of its groove. With
the other hand, push the top of the o- ring forward. It
will roll out of the groove and can be easily removed.
If there is more than one o- ring to be removed, always
remove the rear o- ring first. This will allow the o- ring
to slide over the forward rings without falling into the
open grooves.
Step 4
Thoroughly brush clean all disassembled parts in the
cleaning solution, making sure all lubricant and mix film
is removed. Take particular care to brush clean the
draw valve core in the freezer door(s). Place all the
cleaned parts on a clean dry surface to air dry
overnight.
Step 5
Return to the freezer with a small amount of cleaning
solution. With the black bristle brush, brush clean the
rear shell bearing(s) at the back of the freezing
cylinder(s).
Figure 25
Step 6
Wipe clean all exterior surfaces of the freezer.