Taylor 390, Operator'S Manual, Page: 20 / 36

6-2
OPERATING PROCEDURES
Model 390
Operating Procedures
6
6. Lubricate the baffle assembly O-ring and install it on
the front end of the baffle assembly. Install the guide
bearing on the rear end of the baffle assembly. Install
the bearing end of the baffle assembly into the pilot
hole in the drive shaft.
7. Before assembling the freezer door, check the
following for any nicks, cracks, or signs of wear: front
bearing, door gasket, draw valve, O-rings, and all
sides of the door assembly, including the inside of the
draw valve bore. Replace any damaged parts.
8. Install the O-rings on the draw valve and lubricate
them.
Figure 6-2
9. Insert the draw valve into the door, leaving
approximately 1/2 in. (12.7 mm) of the valve sticking
out the top of the door.
Figure 6-3
10. Rotate the draw valve so the flats on the top of the
draw valve are perpendicular to the door face.
Figure 6-4
11. Insert the ice buster through the door spout and into
the slot located just above the lower O-ring.
Figure 6-5
12. With the ice buster in place, rotate the draw valve to
allow installation of the draw handle. This will lock the
ice buster in place. Install the draw handle pin, and
close the draw valve by moving the handle to the left.
Figure 6-6
101611
101626
11115
101612