Taylor-Dunn R 380-36, Operator'S And Service Manual

Page: 57 / 260

Maintenance, Service, and Repair
Steering Page 7
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
REPLACE THE STEERING SHAFT
(NON-TILT STEERING)
6. If equipped with a horn switch in the steering wheel,
remove the switch, disconnect the wires from the
switch and cut the terminals off of the wires.
7. Remove the steering wheel.
NOTE: Refer to Replace the Steering Wheel
section for information regarding
removing the steering wheel.
8. Remove the upper steering shaft bushing or bearing
from the steering column.
9. Remove the steering gear access cover from the
steering column (if equipped).
10. Remove and discard the pinch bolt and nut from the
steering shaft coupler.
NOTE Most vehicle configurations will now allow the
steering shaft to slide off of the steering gear
input shaft and then back down out of the steering
column. If there is not enough clearance for this
procedure then the steering gear must be
removed. Refer to
Replace the Steering Gear
for information regarding removing the steering
gear.