Taylor-Dunn MX-026-00, Operation, Maintenance, And Replacement Parts Manual

Page: 111 / 192

Curtis PMC Troubleshooting
Page 17
STOP
Stop, do not continue. If you reached this point without a solution, then you may have an
unanticipated problem or have made an error during testing. It is important to review the
trouble shooting steps that have led to this point. The tests may need to be repeated.
Connect the test light across the Normally Closed contacts of
the Forward solenoid. Refer to your vehicles wiring diagram
to identify the position of the forward solenoid.
Close all interlock switches, turn the Key Switch ON,
and place the F&R Switch in Reverse.
Depress the accelerator pedal fully.
•
If the light comes on then the Forward solenoid has
failed. Stop trouble shooting here and repair the
problem. When the repair is completed, completely
retest the vehicle before lowering the drive wheels to
the ground.
Reverse (does not run in forward)
Connect a voltmeter across the PMC KSI terminal and battery
negative.
Close all interlock switches, turn the Key Switch ON,
and place the F&R Switch in forward.
•
If the voltage is not at battery volts then go to the Key
Switch sequence.
Connect a voltmeter across the Forward Solenoid coil
terminals. Refer to your vehicles wiring diagram to identify
the position of the forward solenoid.
Close all interlock switches, turn the Key Switch ON,
and place the F&R Switch in forward.
Depress the accelerator pedal fully.
•
If the voltage is not at battery volts then go to the F/R
Switch sequence.