![background image](http://html1.mh-extra.com/html/taylor-dunn/bt-280-36/bt-280-36_operators-manual_823364021.webp)
Page 21
Operator Manual
MB-280-02
Smart View Display
The Smart View Display (SVD) functions as a Battery Status Indicator (BSI), Hour Meter (HM),
speed controller status monitor, and as an optional maintenance monitor feature. The operation of
each of these functions is described below.
HM:
Depending on the revision level of the
controller, there are one or two hour meter
functions, Key Hours and Run Time Hours
(see note below).
Run Time Hours is the accumulated length of
time that the vehicles has been in operation.
Time is accumulated when the FS-1 switch in
the accelerator module is closed.
The Run Time Hours will be displayed as
indicated by the Run Time Hours Indicator
located at the left of the display. The icon
represents a motor symbol with a “T” in the
center.
BSI:
A bar graph representing the current state
of charge is located across the top of the
display. When the batteries are fully charged,
all segments of the bar graph will be on. As
the batteries are used, segments will turn off
in the order of right to left.
When the batteries are discharged to 75%,
the last three segments will flash indicating
that you are approaching the end of the
battery cycle. At this time, the vehicle’s
batteries should be charged as soon as
possible.
At 90%, all segments will flash and the
vehicles speed will be reduced. At this time,
the vehicle should be removed from service
for charging. Discharging beyond 90% will
result in damage to the batteries that will
shorten the battery life-span.
Note: The battery status gauge as well as
any faults indicating low battery voltage
will not reset until the batteries have
successfully completed a charging
cycle.
Summary of Contents for BT-280-36
Page 55: ...Index 55 ...