Page 29
B-210 / B-200 Curtis System Operator Manual
MB-210-14
Emergency Stop Switch
Optional. This vehicle may be equipped with an optional Emergency Stop Switch. The switch is
a large red mushroom shaped knob that will be within reach of the driver. The actual mounting
location may vary depending on the vehicle configuration.
The Emergency Stop Switch should be used if the vehicle starts to operate in an unexpected
manner or if there is an odor or sound that may indicate an overloaded electrical circuit. If any
of the above occurs, immediately and safely pull to the side of the road and stop. Then push
on the switch knob and exit the vehicle. Do not reengage the switch until the vehicle has been
inspected by a qualified technician.
The Emergency Stop Switch should only be activated if the vehicle must be immediately stopped.
Do not use the switch when only parking the vehicle.
Stopping
Release the throttle pedal and use your right foot to press the brake pedal. The amount of force
required to stop the vehicle will vary depending on the environment and load on the vehicle.
Unless in an emergency, do not turn the start witch OFF until the vehicle has come to a complete
stop. This vehicle may be equipped with an optional electromagnetic park brake. Turning the
start switch OFF will immediately engage the brake and abruptly stop the vehicle. If this is done
while is still in motion then it will result in accelerated wear of the park brake.
This vehicle is equipped with regenerative (regen) braking. Regen braking uses the stored energy
of the moving vehicle to generate electricity. The generation of electricity slows the vehicle down
and the power generated is put back into the batteries increasing the driving time of your vehicle.
There is more than one regenerative braking mode. The mode used depends on the current
driving conditions as follows:
•
While Coasting:
When you release the throttle pedal, the Neutral Regen mode is
selected and gradually slows the vehicle. Only a small amount of
power is generated.
•
Changing Direction: The Direction Regen mode is selected when the direction of the
vehicle is changed while the vehicle is in motion. In this mode the
motor is reversed and slows the vehicle to a stop and then continues
in the opposite direction.
Parking
1. Bring the vehicle to a stop at an authorized parking space.
2. Place the Direction Control switch in the center OFF position.
3. Turn the start switch OFF.
4. Firmly set the parking brake.
5. Remove the key from the Start switch. The driver should keep the key in his/her possession.
Note: If parking this vehicle on an incline, turn the wheels to the curb, or block the wheels.
Brakes contaminated with water or mud may not work properly until dried out.
ALWAYS test brake operation immediately after driving through puddles or mud. Failure
to test brake operation may result in the inability to stop in an emergency causing in
severe personal injury and/or property damage.
WARNING
Transporting Pets
Pets should only be transported in a pet carrier that is securely tied down on the rear cargo deck.
