tayco Norris Boardroom Table 1 Surface, Installation Manual

Page: 17 / 20

Norris boardroom table – 3 Surfaces
Figure 1
Tools & Hardware Needed
8540-1282
Drill Rubber Mallet Box Wrench Robertson # 2 3/8-16" X 1-1/2"
Hex Bolt
8540-0789_SCREW MENDPLATE-BLK 8540-0770_Dowel
#10 X 1" Pan Head
Screw Top Bolt Mending Plate Wooden Dowel
Note: The procedure below is for
Boat, Straight, and Super Ellipse
boardroom tables.
1.
Please refer to page 10.
Follow Steps 1 - 3 to install the
table base.
2.
Place the three surfaces on top
of table base and attach them
together by inserting wooden
dowels, (Figure 1).
3.
Please refer to pages 11-13.
Follow Steps 5 - 9 to connect
the surfaces, table base, covers
and set the power grommets.
FEBRUARY 2020 norris 14