tayco Cosmo, Installation Manual

Page: 20 / 111

3. Remove the tiles on one side of
each panel.
4 . Rotate one panel to create a
90-degree angle.
5. Using a 6-inches hex key, install
the 25 mm or 1-inch hex screws
into the inside edge of the panels;
this will protrude into the
"T"-CONNECTORS, (Figure 3).
6. For the third panel follow the
same procedures as stated
above.
7. Insert between connectors pieces
of 2 1/2-inches diameter sponge
vertically, so that light will not
protrude through, (Figure 3).
8. Re-install the tiles previously
removed, if there is no panel to
install next to it.
FIGURE 3
TOP VIEW
torpedo level drill 6" hex key
tools needed
box wrench
hardware needed
panel height (inches) 37 45 53 61 69 77 85
T connector 2X 3X 3X 3X 3X 3X 4X
25mm hex screw 12X 18X 18X 18X 18X 18X 24X
2 1/2-INCHES
SPONGE
panel assembly - "T" configuration (cont'd)
2 1/2-INCHES
SPONGE
NOTES:
> Do not re-install the tiles right
away, might need them off to
install next frames.
> Sponge to be inserted before last
panel is installed.
"T"-CONNECTOR
25mm HEX
SCREW
25mm HEX
SCREW
MARCH 2017 cosmopolitan 20