Taurus VT3, Assembly And Operating Instructions Manual

Page: 18 / 28

VT3
18
Error Cause Solution
The plate has stopped
moving
The standard training time of
the plate has elapsed.
Re-start the plate after 10 minutes.
The plate is not
reacting to the remote
control
The remote control is too far
away from the plate.
Shorten the distance between the
remote control and the plate.
The plate fails to
operate properly
The plate software crashes
when receives too many
commands.
Turn of the plate at the power switch
and re-start the plate.
4.3 Maintenance and Inspection Calendar
To avoid damage from body sweat, the equipment must be cleaned with a damp towel (no solvents!)
after each training session.
The following routine tasks must be performed at the specified intervals:
Part Weekly Monthly Quarterly Half-yearly Yearly
Display console C I
Plastic covers C I
Screws and cable
connections
I
Training bands and
handles
C/I
Legend: C = clean; I = inspect
5 DISPOSAL
At the end of its operational life, this equipment cannot be disposed of in normal household waste.
Instead, it must be disposed of via an electricals recycling centre. Further information can be
obtained from your local authority‘s recycling service.
The materials can be recycled as per their symbols. Through the reuse, recycling
of materials or other forms of recovery of old equipment, you make an important
contribution to the protection of the environment.