Taurus TF-KABELZUG, Assembly And Operating Instructions Manual

Page: 18 / 36

18
Hi-Low
Step 5: Cable Routing
L
NOTICE
To perform the cable routing, you might need to loosen some of the pulleys.
1. Detach the ball ends of the cable (9) and place one end of the cable under the upper pulley in
the double pulley block (13a).
2. Reattach the ball end to the cable (9) in this position to ensure the cable (9) does not pull
through.
3. Pass the cable (9) up and over the pulleys (20a) and (20b).
4. Pass the cable (9) down and under the pulley (20c).
5. Pass the cable (9) up and over the pulleys
(20d) and (20e).
6. Pass the cable (9) down and under the pulley
(20f).
7. Pass the cable (9) up and over the lower
pulley in the double pulley block (13b).
8. Reattach the other ball end to the cable (9).
9. Attacth the handle straps (18) and hooks (10)
to the cable ends (9).
10. Tighten all bolts and nuts.
Cable Adjustment
If the cable is too tight or too loose, you can adjust
the tension by changing the locking position of
the pulley mounted in the pulley block (20c).