Taurus ELECTRO G2, Flight Manual And Maintenance Manual

Page: 84 / 96

84
TAURUS ELECTRO
www.pipistrel.si
REV. 3
Handling and maintenance
Periodical cleaning of all outer surfaces with car shampoo
Clean as you would clean your car starting at the top and working your way downwards using a soft
sponge. Be careful not to use a sponge that was contaminated with particles e.g. mud, fine sand)
not to grind the surface. While cleaning, do soak the surface and the sponge many, many times. Use
a separate sponge to clean the bottom fuselage, as is it usually more greasy than the rest of the air-
frame. When pouring water over the airframe, be careful not to direct it over the wing-fuselage join-
ing section, parachute rescue system straps and cover, pitot tube, tail static probe and motor covers.
Always water the shampooed surfaces again before they become dry! Thereafter, wipe the whole of
the aircraft dry using a drying towel, chamois or artificial leather skin.
Also, clean the Mylar wing and tail control surfaces gaskets. Lift the gaskets gently and insert ONE
layer of cloth underneath, then move along the whole span of the gasket. Ultimately, you may wish
to apply Teflon grease (in spray) over the area where the gaskets touch the control surfaces.
Polishing by hand
Use only the highest quality polishing pastes WITHOUT abrasive grain, such as Sonax Extreme no.1
or similar. Start polishing on a clean, dry and cool surface, never in the sunshine!
Machine polishing requires more skills and has its own particularities, therefore it is recommended
to leave it to a professional.
Cleaning the Plexy-glass transparent surfaces
It is most important to use really clean water (no cleaning solutions are necessary) and a really clean
drying towel (always use a separate towel ONLY for the glass surfaces). Should the glass surfaces be
dusty, remove the dust first by pouring water (not spraying!) and gliding your hand over the surface.
Using the drying towel, simply glide it over the surface, then squeeze it and soak it before touch-
ing the glass again. If there are bugs on the windshield, soak them with plenty of water first, so less
wiping is necessary. Ultimately, dry the whole surface and apply JT Plexus Spray ($10 USD / €10 EUR
per spray) or at least Pronto antistatic (transparent) spray and wipe clean with a separate soft cotton
cloth.