Taurus C60WHAL, Manual

Page: 9 / 28

NOTE: When the carbon filter is connected, the
suction will be lower.
Instructions for use
Before use:
Remove the appliance’s protective film.
Make sure that all products’ packaging has been
removed.
Ensure that the selected tension on the voltage
selector coincides with the tension of the mains.
Use:
Connect the appliance to the mains.
Turn the appliance on, by using one of the speed
selection buttons (Fig.2).
Light function:
The appliance includes a light function, which
illuminates the working area under the appliance
(Fig.2).
Once you have finished using the appliance:
Stop the appliance by pressing the stop button
(Fig.2).
Practical tips:
It is recommended to keep the filters clean,
grease and dirt in the filters decreases the
efficiency of the engine and increases its energy
consumption.
Adjust the extraction speed according to the
amount of smoke, working at high speeds with
little smoke consumes more energy.
Cleaning
Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
Remove the filters, clean in hot, soapy water or
in a dishwasher. Replace parts correctly.
Cleaning is recommended every month.
NOTE : If you clean the filters in the dishwasher,
they may change colour slightly.
Never submerge the appliance in water or any
other liquid or place it under running water.
If the appliance is not maintained in good
cleaning condition, its surface can degrade and
inexorably affect the life of the appliance and
lead to a dangerous situation.
Then dry all parts before its assembly and
storage.
Changing the bulb/s:
LED
You must purchase the specific spare part for
your model.
Steps to follow:
1. Disconnect the hood from the mains.
2. Press the LED to push towards the inside.
3. Disconnect the connector.
4. Introduce the new LED and push to place it in
its place.
5. Reconnect the connector.
Changing the filters:
For activated carbon filters (if applicable), it is
advisable to replace them at least once a year or
every 48 hours of operation.
In the case of permanent mesh filters, they do
not need to be replaced.
Supplies
Supplies can be acquired from distributors and
authorised establishments (such as filters,
bulbs...) for your appliance model.
Always use original supplies, designed
specifically for your appliance model.