Taurus ACCENTO LATTE, Instructions For Use Manual, Page: 23 / 98

Problem Cause Solution
The indicator of the Latte (4.4) and
warning indicator (2.4) flash at the
same time.
The heating element has no signal,
and the brewing motor does not work
normally.
Turn off the appliance and restart it.
Please contact the service department
if the problem can not be solved.
The cream is not rich. The ground coffee is too coarse. Turn the grind setting knob clockwise
to select the proper setting.
The type of coffee bean used is
wrong.
Use coffee beans which are suitable
for brewing espresso.
Coffee comes out slowly or comes
out drip by drip.
The ground coffee is too fine. Turn the grind setting knob anticlock-
wise to select the proper setting.
Coffee does not come out of the
coffee outlet.
The coffee outlet is blocked. Clean the coffee outlet with a tooth-
pick.
The machine can not be activated. The power plug has not been con-
nected well in place.
Connect the power plug to the main
power supply of the machine.
The power source is not connected
well.
Connect the power source of the
machine.
The On/Off button is not turned on. Turn on the On/Off button.
The brewer can not be removed. The machine is not turned off cor-
rectly.
Turn off the machine and then turn it
on again to make the brewer reset.
Please contact the after-sales depart-
ment if the problem can not be solved.
The brewer is blocked. Contact the after-sales department.
The milk foam is too large or sprays
from the milk outlet.
The milk is not cold enough or the
milk used is not suitable for being
frothed.
It is recommended that the tempera-
ture of the milk should be 5-10°, and
the protein content of milk should be
at least 3%.
The milk frother is too dirty. Clean the milk frother.
Both the residue full indicator and
brewer cleaning indicator illuminate.
You may empty the residue-collection
container and clean the brewer when
the coffee machine is turned off.
Please always empty the residue-col-
lection container and clean the brewer
when the coffee machine is turned on.
And install them again after waiting for
at least 3 seconds.
The residue-collection container is
not full, but the machine prompts
you to empty the residue-collection
container or clean the brewer.
The counter is not reset after empty-
ing the residue-collection container or
cleaning the brewer.
After replacing the residue-collection
container or the brewer, always wait for
about 3 seconds to make the counter
reset to zero. Always empty the resi-
due-collection container and clean the
brewer when the coffee machine is
turned on. The counter will not be reset
if the residue-collection container is
emptied or the brewer is cleaned when
the coffee machine is turned off.