tau K126MA, Installation Manual

Page: 26 / 80

26 K126MA
PROG
CH1 CH2
The absorption registered is shown according to the following diagram:
Level DL7 DL8
(
Off
) (
Off
)
(
Green
) (
Off
)
(
Green
) (
Green
)
(
Green
) (
Yellow
)
(
Yellow
) (
Green
)
(
Yellow
) (
Yellow
)
(
Yellow
) (
Red
)
(
Red
) (
Yellow
)
(
Red
) (
Red
)
After 5 minutes from the function activation, the board automatically resumes to the standard LED
visualization (to resume manually press simultaneously CH1, PROG and CH2).
RESTORING AUTOMATIC OPERATION
Should the Bar need to be operated manually, use the release system. After the manual operation:
• after a Mains Power Failure, such as a black-out (controller remains disconnected for a certain
time) or after a manual release (without power shortage to the controller for more than 5 seconds),
the automation will be moving slowly to allow the Controller to establish its Limits (REALIGNMENT
procedure).
433.92 MHz BUILT-IN RADIO RECEIVER
The radio receiver can learn up to a maximum of 86 rolling codes (BUG2R, BUG4R, K-SLIM-RP, T-
4RP) which can be set on the two channels as required.
The first channel directly commands the control board for opening the automatic device; the second
channel commands a relay for a N.O. no-voltage output contact (terminals 19 - 20, max. 24V AC, 1 A)
and the third channel controls directly the pedestrian opening from the controller.
LEARNING SYSTEM FOR RADIO CONTROL DEVICES
CH1 = 1
st
channel (only OPEN/CLOSE)
CH2 = 2
nd
channel
CH3 = 3
rd
channel (only PEDESTRIAN)
1_ press button CH1 briefly to associate a radio control device with the OPEN/CLOSE function;
2_ the (green) DL8 LED is ON to indicate the code learning mode has been activated (if no code is
entered within 10 seconds the board exits the programming function);
3_ press the button of the relative radio control device;
4_ the (green) DL8 LED turns off to indicate saving is complete and then on again immediately wait-
ing for other radio control devices (if this is not the case, try to re-transmit or wait 10 seconds and
restart from point 1);
5_ to memorise codes to other radio control devices, press the key to be stored on other devices
within 2-3 sec. After this time (DL8 LED turns off) must repeat the procedure from point 1 (up to a
maximum of 86 transmitters);
6_ if you wish to save on the 2nd channel, repeat the procedure from point 1 using the CH2 key instead
ENGLISH