Tatung TAW-A70FD, Service Manual

Page: 6 / 41

4. DIRECTIONS FOR INSTALLATION AND USE
5 DIRECTIONS
The opening must not be obstructed by carpeting when the washing machine is installed on a carpeted floor.
" "
Location Of Washer
Check location where washer will be installed. Make sure you have everything necessary for correct installation.
Proper installation is your responsibility.
• Do not place or store your washer below 0˚C(32˚F) to avoid any damage from freezing.
• Install the washer on the horizontal sold foor.
NOTES
If the washer is installed on an unsuitable floor, it could make considerable
noise, vibrate and cause a malfunction.
If washer is not level, adjust the front leg(A) up or down for horizontal set-
ting.
• Earthed electrical outlet(B) is required with 20cm of bottom back of
washer cabinet.
• Hot and cold water faucets (C) must be within 1M of the upper back of
the washer cabinet and provide water pressure 0.3kgf/cm 2 -
8kgf/cm 2 (2.94N/cm 2 -78.4N/cm 2 ).
" "
Drain System
Never forget to install drain hose before operating your washer.
The packing box is opened, there are a drain hose.
• Conect the drain hose to the drain outlet at the back side of the washer.
1
In case that it goes over a door sill.
Don’t let the height of the drain
hose exceed 20cm from the bottom
of washer.
2
In case of extending the drain hose.
Don’t let the total length exceed 3m.
3
Be careful that the end of the drain
hose is not immersed in water.
Non-Pump Model
C
UP DOWN
B
A
Drain hose
20Cm
3m