13
Marchesan Implementos e Máquinas Agrícolas “TATU” S.A.
GNLCR
• Place the external lock (A) along with the axis (B).
• Then, tighten the nut (C) passing 5 mm from the axis face.
• Place the disc blades (D), bearings (E) and spacer spools (F), following the
instructions on the previous page.
• Place the internal axis lock (G) and a nut (C-1).
• Place the bolt (H) that fasten the lock nut (I), along with a spring washer and a nut,
only on the external side of the gangs.
• Use the wrenches (A) from page 11 to tight the gangs, as follows:
1) Place one of the wrenches in the external side of the gangs (locked side) supporting
it on the ground. (See figure on page 14).
2) On the internal side, use the other wrench and tighten the gangs to get maximum
torque.
3) To tighten, the gangs must remain underpinned with a piece of wood or another
object, preventing it from moving. (See figure on page 14).
• Finally, put the bolt (H-1) and position the lock nut (I-1), fastening it with a spring
washer and nut.
Disc gangs assembly
Assembly
IMPORTANT
•
Check the correct side of the bearings and spacer spools according
to the concavity of the disc blades.
Grease fitting or plug
Summary of Contents for GNLCR
Page 1: ...INSTRUCTIONS MANUAL GNLCR ...
