26
Filling water
Dosage:
Only use chemical products recommended by the manufacturer.
Dosing examples (The concentration is product dependent):
Start of operation
Cleaning method
Direct method:
Scrubbing and vacuuming in one pass.
Indirect working method:
Apply the cleaning solution (only scrubbing), afterwards scrubbing and
vacuuming.
The cleaning methods are described in detail in the ”Method Card”. You can
obtain this from your TASKI partner.
Refilling the solution tank
When the tools are no longer sufficiently supplied with the solution, the tank
containing the solution is empty.
End of operation
Caution:
Maximum permissible water temperature 60 °C/140 °F.
• Switch the machine off.
• Lift the tank lid.
• Fill water into the solution tank.
Maximum permissible filling level (page 25).
Caution:
Wear protective gloves, goggles and the corresponding
(protective) work clothing when handling chemical products!
Caution:
Using other chemicals (e.g. chemicals containing solvents,
chlorine, hydrochloric acid and hydrofluoric acid) can damage or
destroy the machine.
Instructions on the product’s
packaging
Tank capacity
The volume per
tank filling
0.25%
25ml to 10l water 22l
50ml = 0,05l
0.5%
50ml to 10l water 22l
100ml = 0,1l
• Add the product measured with the dosing aid to the water in the solution
tank.
Caution:
Always wear non-slip shoes and appropriate work clothing while
working with this machine!
• Lower the squeegee.
• Unlatch the foot lever and slowly lower the tool.
• Plug the power supply cord into the mains
socket.
• Switch the machine on (main (ON/OFF) switch).
The main switch lights up.
• Push the cleaning solution switch.
The main switch lights up.
• Push the suction unit switch.
The indicators light up briefly.
• Adjust the volume of the cleaning solution.
max.60
°
C
max.140
°
F
• Pull the operating lever.
By doing this the tool is activated.
Under certain circumstances, the driving of the machine can be
impaired by a special combination of surface/soiling and cleaning
product.
This effect can be reduced by special wheel options.
Caution:
Do not clean without solution, as it could cause floor damage.
• Stop cleaning.
• Refill the tank, see page 26.
• Stop the flow of solution.
• Drive a few metres so that the tool rotates further for a short time. You will
avoid dripping by doing this.
Very important when using contact pads!
• Release the operating lever.
• To raise the tool, press down the foot pedal until
it latches it into place.
• Drive on a few metres further in order to pick up the remaining soiled
solution.
• Raise the squeegee.
Allow the suction unit to continue running until
the rest of the soiled solution has been sucked
into the hose.
• Now switch the suction unit off.
• Switch the machine off (main (ON/OFF) switch).
Always drain and clean the recovery tank every time you use the
machine.
If the dsoiled solution is allowed to stand, unpleasant smells and
deposition of the dirt will take place after a few hours.
