26
Attach squeegee
Filling water
Dosage:
Only use chemical products recommended by the manufacturer.
The dosing aid is marked for a 0.5% cleaning solution.
The level indicators on the tank correspond to those on the dosing aid. The
machine type is noted on the dosing aid!
Dosing examples (The concentration is product dependent)
Beginning work
Cleaning method
Direct method:
Scrubbing and vacuuming in one pass.
Indirect working method:
Apply the cleaning solution (only scrubbing), afterwards scrubbing and
vacuuming.
The cleaning methods are described in detail in the ”Method Card”. You can
obtain this from your TASKI partner.
Refilling the solution tank
The rattling noise from the pump indicates that the solution tank is empty.
• Switch the machine off.
• Raise the squeegee and loosen the fixing
screws on the squeegee.
• Assemble the squeegee and tighten the fixation
knobs.
• Attach the suction hose to the squeegee.
Caution:
Maximum permissible water temperature 60 °C/140 °F.
• Switch the machine off using the keyswitch and remove the key.
• Reach into the opening between the tank lid and
the tank.
Palm facing upwards.
• Open the lid until the self support locates on the tank wall.
• Remove the dosing aid.
• Fill water into the solution tank.
Maximum permissible filling level (Page 23).
Caution:
Wear protective gloves, goggles and the corresponding
(protective) work clothing when handling chemical products!
Caution:
Using other chemicals (e.g. chemicals containing solvents,
chlorine, hydrochloric acid and hydrofluoric acid) can damage or
destroy the machine.
Dosage
Tank capacity
Dosing aid
0,5%
1/2
1 x 1/2
MAX
1 x MAX
1%
1/2
1 x MAX (2 x 1/2)
MAX
2 x MAX
1250
750
max.60
˚
C
max.140
˚
F
• Dosing aid application
• Add the product measured with the dosing aid to the water in the solution
tank.
• Lift the tank lid slightly.
• Gently press the self support inwards.
• Close the lid.
• By exerting slight pressure onto the front part of the lid, you can click it into
the latch.
Caution:
Always wear non-slip shoes and appropriate work clothing while
working with this machine!
• Lower the squeegee.
• Switch on the keyswitch.
The indicators light up briefly.
• Lower the brush unit using either the brush unit button or brush unit pedal,
see Page 25.
• First press the solution dosing control button,
and then the vacuum on.
The indicators light up briefly.
• Choose the volume of solution (+/- button for
volume control)..
The chosen setting is displayed with green
lights.
• By gently pressing the speed control in the
direction of drive, the machine is set in to
motion.
The tools start to turn and the solution is fed
through the centre.
Caution:
Do not clean without solution, as it could cause floor damage.
• Stop cleaning.
• Refill the tank, see Page 26.
