24
Preparation for operation/Operation
Batteries
Safety measures when working with batteries:
Battery connection diagram
Charging procedure (traction block batteries with integrated charging
unit)
After completing the charging and with immediate use
Charging procedure (traction block batteries with external charging unit)
Charging procedure (wet batteries with external charging unit)
• Protective goggles must be worn when working on the
batteries.
• Do not subject batteries to an open flame or heat as there is a
danger of explosion from the electolytic gas present in the
cells!
• No smoking!
• Danger of chemical burns!
Caution:
The battery must always be clean and dry. Do not place any
metallic objects on the battery.
The integrated charging unit is only suitable for maintenance-free
gel traction block batteries.
Caution:
Batteries may only be installed or dismounted by customer
service personnel or specialists approved by JohnsonDiversey
who are aware of all the safety regulations that apply here!
• Check that the machine has been switched off with the keyswitch.
• Disconnect the battery from the machine using the battery disconnection
socket.
• Plug the power supply cord into the mains socket.
The yellow indicator lights up permanently until
approx. 90% of the battery capacity has been
reached. After that, the indicator blinks until the
battery is fully charged.
-
+
-
+
-
+
-
+
-
+
-
+
-
+
-
+
-
+
Power
board
Power
board
+
-
+
-
+
-
+
-
SWINGO 1250B
Onboard
charger
Onboard
charger
Power
board
Power
board
Onboard
charger
Onboard
charger
-
+
-
+
-
+
-
+
-
+
+
-
+
-
+
-
+
-
SWINGO 750B
When the charging process is complete, the
green indicator lights up.
• Leave the power supply cord connected to the mains until you use the
machine again. The on-board charger unit automatically monitors and
charges the batteries. The energy consumption in the mode is limited to a
few milliwatts.
If a fault occurs during the charging process as
the result of a defect in the charging unit, an
interruption of a cable or a defective battery cell,
the red indicator will light up.
• Unplug the connection to the mains socket.
• Connect the battery to the machine with the battery disconnection socket.
• Check that the machine has been switched off with the keyswitch.
• Disconnect the battery from the machine using the battery disconnection
socket.
• Connect the battery disconnection socket to the external battery charging
unit (pay attention to the voltage from the mains supply socket).
Caution:
Follow the instructions of use for your battery charger!
Caution:
If the machine is assembled with a wet battery kit (optional) the
machine must be used with wet batteries only!
Wet batteries must not be charged with the internal charger!
Battery compartment must be open during charging.
Wet batteries must be charged in ventilated rooms only!
The gas given off could be ignited!
• Switch the machine off using the keyswitch and remove the key.
• Disconnect the battery from the machine using the battery disconnection
socket.
• Check that the tanks are empty.
• Unlock the battery compartment (with a screw
driver) and in a sufficiently large area, lift the
tank until it locates into its self support position.
Tank position for charging.
• Connect the battery disconnection socket to the external battery charging
unit (pay attention to the voltage from the mains supply socket).
Caution:
Follow the instructions of use for your battery charger!
• Turn on the battery charger.
