END OF USE AND WINTER STORAGE INSTRUCTIONS
15
1) When finished using the pressure washer, you must first drain and rinse the detergent tanks.
2) Run the pressure washer in low pressure until all of the detergent is drained from the detergent
tanks.
3) Pour clear water into the tank(s) and run it through on low pressure as though it were detergent.
4) Turn the machine OFF and squeeze the trigger to release the trapped pressure inside of the
machine.
5) Remove both the garden hose and high pressure hose from the unit.
6) Turn ON the machine and allow it to run for 5 seconds. (This will clear out most of the water
trapped in the pump).
7) Unplug the machine and store the accessories and powercord as shown below. (Fig.17)
8) Store the machine and accessories in a dry, climate controlled environment.
Do not store the
machine or accessories in a place where the temperature could drop below 40°F. FREEZE
DAMAGE IS NOT COVERED BY THE WARRANTY.
Fig. 17
2) Allow detergent to remain on the surface for short time before rinsing. Do not allow the
detergent to dry on the surface.
3) Rinse with clean water under high pressure. On a vertical surface, first rinse from the bottom
up, then rinse from the top down. Hold nozzle 6 to 8 inches from the work surface at a 45° angle
using the flat spray as a peeling tool rather than a scrub brush.
4) When you have completed use of the detergent injection system, continue to run in low pressure
position and flush clean water through the detergent tank until it is thoroughly cleaned.
NOTE: Failure to clean properly will cause the injection system to become clogged and inoperable.
CLEANING TECHNIQUES
