25
Chapter 5
Basic Operations
the event recording. (Remember, the buffered video will not contain audio.)
The moment you double-press the EVENT button, both video and audio will be recorded from the camera and
GPS coordinates (if the system is paired to a GPS-capable smart phone) will be recorded. This will continue
throughout the duration of the recording until you terminate the recording.
The AXON Flex hardware provides you with indications that it is recording in EVENT mode:
t
At the start of an event and every two minutes during an event, the system will beep twice.
t
The Operation LED on top of the controller will blink red.
The camera must be attached to the controller system in order for it to record video in EVENT mode. If the
camera is not connected to the controller, you will not record any video.
If the camera becomes disconnected
from the controller during an event, the system will stop recording.
To exit EVENT mode and return to BUFFERING mode, press the EVENT button for approximately 3 seconds. The
3-second requirement reduces the possibility of accidentally exiting EVENT mode.
To end a recording and turn off the system, move the on/off switch to the “off” position. When you end a recording
with the on/off switch you will not go into BUFFERING mode, instead the system will turn off completely.
NOTE: An event not recorded by the AXON Flex system cannot be played back or downloaded to your computer.
Battery Status
Press the Battery button to determine the percentage remaining in the controller battery. See
AXON Flex
Controller
in
Chapter 2: Hardware
for details on the Battery LED functions.
Adjusting the Volume
Press the volume/pairing button on the camera to adjust the volume of the audio prompts.
Volume/Pairing Button
The volume has four settings. At each level, the camera beeps, providing you with a sample of the volume:
t
Low
