TASCAM HS-2
67
NOTE
To load a take from the current session, instead of steps
1–4 above, touch the session name button at the top right
of the project screen or touch the take name button on
the Home Screen, and touch the
TAKE List
button in
the pull-down menu to open the take selection screen for
the current session.
4 Select the take that you want to load.
5 Touch the
MENU
button in the take selection screen
to open the pull-up menu.
6 Touch the
LOAD
button in the pull-up menu.
7 When a confirmation message appears in the pop-
up window, touch the
OK
button or press the DATA
dial.
When loading completes, the Home Screen opens.
NOTE
You can also press the
e
button for a take to load it.
In this case, no pop-up window appears, and the take
selection screen remains open after loading (the Home
screen does not reopen.)
Setting input monitoring
Turn input monitoring OFF when playing back. If input
monitoring is ON, sound from the input connectors will
be output through all output connectors of this unit.
1 Touch the
INPUT MONITOR
button on the Home
Screen to open a pull-up with the input monitoring
ON/OFF buttons.
2 If input monitoring is on (
ON
button appears blue),
touch the
OFF
button to turn it off (
OFF
button ap-
pears blue).
Playback control
Press the PLAY key to start playback.
Press the PAUSE key to pause playback.
Press the PLAY key again to resume playback.
Press the STOP (RETAKE) key to stop playback.
Press the
.
[MARK
.
] key or /
/
[MARK
/
] key
to switch takes.
Press and hold the
m
[
] or
,
[
] key to
search backward or forward.
Press the
.
[MARK
.
] or
/
[MARK
/
] key while
pressing and holding the SHIFT key to move between
marks.
Press and hold the
m
[
] key or
,
[
] key
while pressing and holding the SHIFT key to search at
high-speed.
NOTE
• On the
PLAY SETUP
screen, you can set whether only
the currently selected take is played or whether all the
takes within the current session are played. You can
also enable and disable repeat playback. (See “Playback
settings (PLAY SETUP)” on page 91.)
• Playback functions can also be used through parallel
control.
Using the call function
Press the CALL (CHASE) key to locate to the point where
playback was last started from playback standby (call
point) and put the unit in playback standby mode.
Using the flash start function in take mode
Using a TASCAM RC-HS20PD (sold separately) or other
remote controller, flash start playback is possible.
For details, see “Flash start function” on page 113.
Take operations
Some takes will be made under session folders. For details
on operations for project and session, see “5–Projects” on
page 36.
The following functions are used for take operations:
• Editing the start time of a take
• Exporting a take
• Deleting a take
• Sorting a take
• Moving the order of alignment of a take
• Editing the name of a take
• Dividing a take (Divide)
• Combining takes (Combine)
• Undoing the previous edit (UNDO)
• Redoing the cancelled edit (REDO)
8–Take mode