16
TASCAM CD-200BT
3 – Preparations
Loading a CD
To load a CD, press the OPEN/CLOSE button on the main unit or
on the remote control to open the disc tray, and put the CD into
the tray with the label facing up.
Press the OPEN/CLOSE button again to close the disc tray. After
loading the disc, the unit reads the disc’s information and the
display shows the total number of tracks and total playback time
if it is an audio CD or the total number of tracks in the current
folder or on the entire disc if it is a data CD.
NOTE
•
When the current source is set to CD, instead of pressing the
OPEN/CLOSE
button to close the disc tray, you can press
the
PLAY/PAUSE
button to close the disc tray and begin
playback immediately.
•
If you open the disc tray while this unit is in use, the
following settings are lost.
– Program
– Current folder (for data CDs)
Selecting the audio to output (current
source)
You can select the CD playback signal, the audio signal received
via Bluetooth or the signal input through the AUX IN jack as the
audio signal output from this unit.
Press the PLAY MODE/PLAY AREA [SOURCE SEL] button while
pressing and holding the DISPLAY [SHIFT] button on this unit,
or press the SOURCE SEL button on the remote control to cycle
through the current source options as shown below.
Cycle through the current source options in the following order.
Current source order
Display when current source is CD
Display when current source is Bluetooth
Display when current source is AUX IN
NOTE
•
AUX IN cannot be selected if nothing is connected to the
AUX IN
jack.
•
When the current source is changed from CD to Bluetooth,
the CD will stop if playing back or paused. When the current
source is changed from Bluetooth to AUX IN, playback of the
connected Bluetooth device will stop.
•
Even if the current source is changed, the CD playback mode,
current folder and program contents will not be erased.
