4
TASCAM BD-MP1MKII
RACK-MOUNTING THE UNIT
Use the supplied rack-mounting kit to mount the unit in a
standard 19-inch rack, as shown below.
Remove the feet of the unit before mounting.
ATTENTION
o
Leave 1U of space above the unit for ventilation.
o
Allow at least 10 cm (4 in) at the rear of the unit for ventilation.
For U.S.A.
Supplier's Declaration of Conformity
Model Number: BD-MP1MKII
Trade Name: TASCAM
Responsible party: TEAC AMERICA, INC.
Address: 10410 Pioneer Blvd., Unit #3, Santa
Fe Springs, California 90670, U.S.A
Telephone number: 1-323-726-0303
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
INFORMATION TO THE USER
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures.
a) Reorient or relocate the receiving antenna.
b) Increase the separation between the equipment and
receiver.
c) Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
d) Consult the dealer or an experienced radio/TV technician
for help.
CAUTION
Changes or modifications to this equipment not expressly
approved by TEAC CORPORATION for compliance could void
the user’s authority to operate this equipment.
LASER INFORMATION
This laser product is a consumer laser product according
to EN 50689 and complies with all consumer laser product
requirements except child appealing products.
This product contains a laser system and is classified as a
CLASS 1 LASER PRODUCT according to IEC 60825-1:2014. This
class does not require special attention in normal use. Do not
take apart to prevent being exposed to the laser beam.
Notes on Laser Product
This product has been designed and manufactured according
to FDA regulations “title 21, CFR, chapter 1, subchapter J, based
on the Radiation Control for Health and Safety Act of 1968”,
and is classified as a class 1 laser product. There is no hazardous
invisible laser radiation during operation because invisible laser
radiation emitted inside of this product is completely confined
in the protective housings.
The label required in this regulation is shown at
1
.
For USA
ATTENTION
o
DO NOT REMOVE THE PROTECTIVE HOUSING USING A
SCREWDRIVER.
o
USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF
PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY
RESULT IN HAZARDOUS RADIATION EXPOSURE.
Optical pickup
Type: SL6167
Manufacturer: Sony Corporation
Laser output: Less than 100 mW on the objective lens (CD)
Less than 100 mW on the objective lens (DVD)
Wavelength: 770 - 800 nm (CD) typ.
650 - 664 nm (DVD) typ.
Optical pickup
Type: SLD3134VL
Manufacturer: Sony Corporation
Laser output: Less than 700 mW on the objective lens (BD)
Wavelength: 400 - 410 nm (BD) typ.
Summary of Contents for BD-MP1MKII
Page 222: ...222 TASCAM BD MP1MKII...
