20
1. Detach tiller from tractor.
2. Make sure tiller is securely blocked and level.
3. Remove PTO shaft from tiller.
4. The tines must be reversed on the tiller before
reverse operation.
7. Loosen and remove a total of (6) bolts, (2) on top of
gear box and (4) underneath.
8. Slide gearbox to left approximately 5”. Side hex
shaft should drop out of gearbox on right hand side.
NOTE:
If hex shaft does not come out of gearbox,
simply slide hex shaft out of side gearbox first and
then remove it from main gearbox.
10. Remove fill plug from top of gear box.
11. Remove flat plug from bottom of gear box. Switch
the fill plug from top of gearbox to bottom and flat
plug from bottom to top.
9. Slide gearbox forward and out.
1. Remove four (4) bolts in each end of tine carrier
2. Carefully remove tine bar assembly and turn 180°
and place in front of the tiller. Before reattaching the
tines, remove gearbox.
REVERSING TILLER TINE DIRECTION
Gearbox is extremely heavy.
Handle with care.
CAUTION
Tine bar assembly is heavy and
contains sharp edges. Handle
carefully!
WARNING
