TAROT
@2016 TAROT All Rights Reserved.
7
2. Gimbal Working Mode
You should select a three-positioned or two-positioned switch in R/C for working mode. Please connect the
corresponding port of the receiver to CH1/SBUS or CH2 of the gimbal controller. Set RC MAPPING in the assistant
software. For different positions, use endpoint fine tune function to set. Please refer to the MODE Channel section
in assistant software for detailed information.
Attentions:
When the
MODE port is unconnected
, the gimbal can only work in the DEFAULT mode. Moreover, during
flight, if the MODE is unconnected suddenly, the working mode would remain the same before disconnection.
After powering up the gimbal, if
the receiver is unconnected
, it works on DEFAULT MODE.
About Working Mode:
Lock Mode
FPV Mode
Descriptions
The angles of Roll and
Pitch keep unchanged.
The angles of Roll
and Pitch axis change
according to the attitude of
the multi-rotor.
Tx Control
Under Control
Under Control
Attitude Stability
√
√
Vibration Reduction
√
√
2.
Working Mode Setup
Choose a
two-positioned or three-positioned
switch:
Take the three-positioned switch as an example: Position 1 refers to FPV Mode; Position 3 corresponds to Lock
Mode. Position 1 and Position 3 can be exchanged.
