30
TARGET ECO I FEEDING, rev.09
TARGET ECO I FEEDING
7.3
Current Status
Select:
6. Current status
The following menu shows the ongoing op-
erations of the feeding system.
•
Start feed cycle #:
Enter the feed cycle you wish to activate.
Accessible if no cycle is currently active.
•
Feeder motor:
This function is used to manually start or
stop the feeder motor. Select “Auto” for
the feeder to run in automatic mode.
•
Actual current:
Shows the current consumption of the
feeder motor.
•
Next feeding time:
Shows the time at which the next feed
cycle will be performed.
Displayed if no cycle is currently active.
•
Current feeding cycle:
Ongoing feed cycle.
Accessible while a cycle is active.
•
Cancel current cycle?
Select “Yes” if you wish to abort the on-
going feed cycle.
Accessible while a cycle is active.
•
Pause feeding?
Select “Yes” to pause the ongoing feed
cycle; select “No” to resume the cycle.
Accessible while a cycle is active.
•
Feed cycle status:
Shows ongoing activity of the feeder (run,
wait, feed, rest, clean).
Accessible while a cycle is active.
•
Remaining rest time:
Countdown of the rest time (in minutes
and seconds).
Accessible while a cycle is active.
•
Remaining clean time:
Countdown of the clean time.
Accessible while a cycle is active.
•
Current ration:
Shows which ration is currently being dis-
tributed.
Accessible while a cycle is active.
•
Current actuator position:
Shows the current position of the
actuator.
Accessible if an actuator is enabled (s. 5.3).
•
Ration 1-8 Consumption:
Today’s feed consumption is displayed
separately for each ration.
Current Status
Exit: Press BACK
Press to Select an item
Start feed cycle #
None
Feeder motor:
Auto
Actual current:
0.0 A
Next feeding time
15:00
Current feeding cycle
3
Cancel current cycle ?
No
Pause feeding ?
No
Feed cycle status
Run
Remaining rest time
0:00 (m:s)
Remaining clean time
0:00 (m:s)
Current ration
1
Current actuator position
0%
Ration 1 Consumption
150 kg
Ration 2 Consumption
250 kg
Ration 3 Consumption
50 kg
15
TARGET ECO I FEEDING, rev.09
TARGET ECO I FEEDING
5.
INSTALLATION SETUP
5.1
Setting the Time & Date
Select:
1. Time and date
•
Press
Enter / Modify
then use the up and
down-arrow keys to set the current day
of the week.
•
Press
Enter / Modify
to step to the next
item then use the up and down-arrow keys
to adjust the value.
•
Proceed in similar fashion to set the whole
time and date.
Time and Date
Wed Nov 07 200X
7 : 07 : 07 PM
Exit: Press BACK Change: Press Modify
Press to Select an item
5.1.1 Adjusting Improper System Time
When the notification message that follows
is displayed onscreen you must set the correct
time and date.
CAUTION:
To ensure accurate feed data,
history logs, and other important system
information, you must set the correct time
and date whenever prompted.
To adjust the time and date when the
“
Improper System Time”
notification appears,
follow the steps outlined in the Time and
Date section.
Note: The notification message
repeatedly disappears and reappears
until the time and date are set.
Improper System Time
Set Time & Date
Exit: Press BACK Change: Press Modify
Press to Select an item