6
Port-O-Slitter Slitter Stand Set-Up/Parts List
10081
T-Knob
10084
1/4-20 2 Way Lock Nut
10088
1/4-20 X 2 1/4" Hex Bolt
10668
28 1/2" Leg with Foot (24" Slitter)
10669
26" Leg (36,48,60" Slitters)
10671
1/4-20 X 2 1/2" Hex Cap Bolt
10676
Wheel Bracket Assembly
10678
1/4 X 2" Faspin
10680
28 1/2" Cross Brace
Part No. Description
1.
Lay out both end assemblies and attach the cross braces
by inserting the register pins into the center holes in the
outside channels and tightening the “T” knobs securely into
the top holes (see detail).
2.
Next, set the height of the vertical supports by removing
the 2" faspins, extending the vertical supports to the
desired position and reinserting the faspins. In most
situations, proper height would be determined by one’s
ability to operate the equipment without having to bend
down.
3.
Extend outside channels fully making sure the horizontal
braces are pushed down all the way. Now place the face
plate tubes into the 2 x 4 brackets and align the holes in
the side walls. Insert 2 each 2 -21/2" faspins per side.
4.
Situate the slitter onto the base plate tubes and align the
holes in the base plate with holes in the base plate tubes.
Tighten the self tapping washer head screws snugly into
place. The base plate tubes do not have to be removed
when detaching the slitter from the stand.
5.
To detach slitter from stand, remove all 4 faspins and
remove from stand.
Optional: Load Pro-Coiler with coil, set into
bottom legs of stand as shown in photo in
upper right and feed coil into receiver end
of Port-O-Slitter.
Note: Reference numbers
may only appear once on
duplicate parts.
PORT-O-SLITTER STAND
24" Port-O-Slitter
Port-O-Slitter
Cut-Off
24" Port-O-Slitter
Stand
(adjustable)
PRO-Coiler
Coil Holder
PRO-Coiler
(optional)
Portable coil holder for use with “Windy”
SP Port-O-Brake and Tapco Port-O-Slitter
PRO-Coiler Features
• Lightweight and easy to use
• Attaches and detaches easily
• Holds up to 24" x 100' coil
• Allows coil changes in seconds
• Helps increase production and eliminate waste
