4
Tanis Technologies 36 Series Filtration Unit
Revised 07.20.2020
unit
9. Ensure that the intake and exhaust
areas are clear prior to starting the
unit. Clogged intakes or exhaust can
cause explosion and/or fire.
10. Keep arms and fingers away from
fan. Avoid all exposure to rotating
parts to prevent injury.
11. Do not attempt to remove/replace
filters while unit is running. Fan
blades can cause severe cuts. Be sure
the unit is disconnected from power
source
12. Maintain the unit in top condition.
Clogged filters can increase potential
for fire or explosion. Follow
instructions for changing filters.
13. Turn the unit
“
off
”
and disconnect
power source before installing or
removing accessories, before adjusting
or changing set
-
ups or when making
repairs. An accidental start up can
cause serious injury.
14. Explosion relief vents are required
for some applications. Consult with an
insurance underwriter or an NFPA
manual to determine proper vent size
and ratio. UNIT DOES NOT CONTAIN
EXPLOSION RELIEF VENTS as shipped
from the factory and must be field
installed per NFPA standards.
15. The AF
-
36xx series units are made
to run continuously, check the filters
regularly for built
-
up debris.
Frequency of filter changes will
depend upon the environment in
which the unit is running.
16. To maintain warranty, be sure to
use only filters that are approved by
the manufacturer.
INSTALLATION AND PREPARATION
BEFORE OPERATING:
Disclaimer:
Although instructions and
recommendations are included for
installation of your air filtration
system, the manufacturer does not
assume responsibility for the
installation of this equipment nor shall
be held liable for direct or
consequential damages resulting from
improper methods, structural failure
or inadequate supports.
Installation: (Diagram on PG. 5)
Installation methods will depend upon
the style of intake options that were
selected when your system was
ordered. The following is a basic guide
line and only a suggestion. A
professional installer should be
consulted.
One option is to mount Uni
-
Strut to
the building structure, dangle
threaded rod through the holes in the
strut with a nut and washer
6”
down
and under the strut. Lift the unit up
until the top of the unit taps the
threaded rod. Thread the connector
nuts onto the ½
”
studs provided in the
top of the unit. Start a ½
”
nut on the
threaded rod to be used as a jam nut.
Now screw the threaded rod into the
connector nuts and tighten up the jam
nuts.
The unit can now be lowered and the
nuts under the strut can be tightened
up to finish the suspension.
The uni
-
strut rails, nuts, and threaded
rods are not provided with the units.
Again, mounting instructions are only
a suggestion. Tanis Technologies is
indemnified from any liability related
to improper installation. Improper
installation could result in person
injury and/or damage to the unit.
Noise Declaration
The figures shown are emissions levels
and are not necessarily safe working
levels. While there is a correlation
between the emission and exposure
levels, this cannot be used reliably to
determine whether or not further
precautions are required.
