8
General Instructions
Important:
· ALL ELECTRICAL WIRING IS TO BE
INSTALLED IN ACCORDANCE WITH
NATIONAL/LOCAL CODES AND REGULA-
TIONS.
· ALL PLUMBING IS TO BE INSTALLED IN
ACCORDANCE WITH
APPLICABLE CODES AND REGULATIONS.
· USE APPROPRIATE PRECAUTIONS
WHILE CONNECTING TRANSFORMER TO
120 VAC POWER SOURCE.
· DO NOT PLUG TRANSFORMER INTO
POWER SOURCE (RECEPTACLE) UNTIL
ALL WIRING IS COMPLETED.
· FLUSH ALL WATER LINES UNTIL WATER
IS CLEAR BEFORE CONNECTING FAUCET
TO SUPPLY STOPS.
Tools Required For Installation of
Faucets
· 8” (200mm) adjustable wrench
· 1/8” hex key wrench
· Basin wrench
· Slotted screwdriver, 3/16”
· Phillips head screwdriver, #1
· Pliers
Prior to Installation:
Prior to installing the T&S ChekPoint
Series Faucet, install the items listed on
next column. Also, refer to Figure 1.
·
Provide electrical receptacle within
approximately 6’ from sink for plug-in
transformer — 120 VAC, 2 amp service
for each plug-in transformer used.
· Scrub or wash-up sink
· Drain line
· Hot and cold water supply lines
Mixing Valve
When installing the faucet with the mix-
ing valve the Installation Instructions
MUST be followed.
Figure 1
Deck-Mount
Wall-Mount